I have just installed the Naviseccli and SAN Monitor for EMC.
I have the same error message as Madrianr, and note from another post that the AX4 SANs may not be supported with SAN Monitor.
Can you confirm that this may be the case or advise on the best method to install
When installing Naviseccli, I did not select certificate or setup the username and password
When installing SAN Monitor, followed the prompts and completed a standard install.
SAN Monitor and Naviseccli are on the same server, this server is not connected to the storage via Fibre, but the IP addresses of the SAN controllers are contactable by all devices.
Any help, greatly appreciated.
Cheers